Plain End 1/4" wide 4-Packs

Available in 3 different grits. Read recommendations below to make the best selection for your scroll saw.
Recommendations:
Fits most 5" scroll saws (Craftsman®, Delta®, DeWalt®, Excalibur®, Ryobi®), but modifications may be required to throat insert or table opening depending upon width of sander used. Be sure to check your table/ throat plate opening before purchasing sanders.
DeWalt® & Excalibur® Scroll Saws only accept the 1/4" sanders unless you drill the table hole larger.
Dremel® 1670, 1671 & 1680: use pin end sanders. Remove nub of plastic at gate to fit into clamp, if necessary.
Delta®: use side mount, cut table insert to fit sander, or remove table insert.
Ryobi® SC 160: use pin end sanders.
Ryobi® SC 162, 162VS & 165: use plain end sanders only.
Hegner®: use pin end sanders.
Does not fit RBI®, Reliant®, or Moto-Shop®.
Plain end sanders fit most conversion kits for mounting blades with plain ends on pin end saws.


Order by part nos.: SC92212BL - 120grit, SC92218BL - 180grit, SC92222BL - 220grit, SC92262BL - Assorted: 180, 220 & (2) 120grits. Click here for more information on ScrollSanders.