Description

Recommendations: How to make the best selection for your scroll saw.
Fits most 5″ scroll saws (Craftsman®, Delta®, DeWalt®, Excalibur®, Ryobi®), but modifications may be required to throat insert or table opening depending upon width of sander used. Be sure to check your table/ throat plate opening before purchasing sanders.
DeWalt® & Excalibur® Scroll Saws only accept the 1/4″ sanders unless you drill the table hole larger.
Dremel® 1670, 1671 & 1680: use pin end sanders. Remove nub of plastic at gate to fit into clamp, if necessary.
Delta®: use side mount, cut table insert to fit sander, or remove table insert.
Ryobi® SC 160: use pin end sanders.
Ryobi® SC 162, 162VS & 165: use plain end sanders only.
Hegner®: use pin end sanders.
Does not fit RBI®, Reliant®, or Moto-Shop®.
Plain end sanders fit most conversion kits for mounting blades with plain ends on pin end saws. More information on ScrollSanders.

Order by part nos.: SC915088BL – 80 grit, SC91512BL – 120 grit, SC91518BL – 180 grit, SC91522BL – 220 grit, SC91564BL – Assorted: 80, 180, 220 & 120 grits.