Previous Product Image

Pin End 1/4″ wide 4-Pack
Scroll Sanders


Plain End 1/2″ wide 4-Packs

Next Product Image

Plain End 1/4″ wide 4-Packs


Available in 3 different grits. Read recommendations below to make the best selection for your scroll saw.
Can also be used in a Jeweler’s Saw Frame! 

SKU: SC92212BL - SC92218BL - SC92222BL - SC92262BL Categories: ,


Recommendations to make the best selection for your scroll saw:
Can also be used in a Jeweler’s Saw Frame!
Fits most 5″ scroll saws (Craftsman®, Delta®, DeWalt®, Excalibur®, Ryobi®), but modifications may be required to throat insert or table opening depending upon width of sander used. Be sure to check your table/ throat plate opening before purchasing sanders.
DeWalt® & Excalibur® Scroll Saws only accept the 1/4″ sanders unless you drill the table hole larger.
Dremel® 1670, 1671 & 1680: use pin end sanders. Remove nub of plastic at gate to fit into clamp, if necessary.
Delta®: use side mount, cut table insert to fit sander, or remove table insert.
Ryobi® SC 160: use pin end sanders.
Ryobi® SC 162, 162VS & 165: use plain end sanders only.
Hegner®: use pin end sanders.
Does not fit RBI®, Reliant®, or Moto-Shop®.
Plain end sanders fit most conversion kits for mounting blades with plain ends on pin end saws. More information on ScrollSanders.
Order by part nos.: SC92212BL – 120 grit, SC92218BL – 180 grit, SC92222BL – 220 grit, SC92262BL – Assorted: 180, 220 & (2) 120 grits. 

Additional information

Weight N/A
Dimensions N/A




You may also like…